Configurations - Vimar Elvox 41001 Instrucciones De Instalación

Configuration
The electronic module is configured via the "SaveProg" sys-
tem software.
However, some parameters can be modified via the electronic
module itself, using the 4 standard buttons and their 4 indi-
cator LEDs, or with the LCD when installed. In some cases
the buttons and LEDs of the additional modules are used too.
Configuration input
The procedure is activated, from the state of rest of the
speech unit, by pressing and holding the
After this time the speech unit will emit a tone. Release the
button and, within 30 s, press the sequence of buttons
forming the password. The timeout is renewed each time the
button is pressed, so there are 30 s from the tone after which
the speech unit goes back to rest.
By default the password is:
Activation is confirmed by a tone.
To navigate in choosing the time to be configured, only the 4
standard buttons are used; the numbering and the function of
the buttons is as follows:
PREVIOUS: to return to the previous
sequence.
NEXT: to move on to the next sequence.
DEL: to exit the configuration menu or a
configuration editing phase, cancelling the
selected one.
OK: to go from the sequence menu to
configuration editing or to confirm the
change to a configuration.
24
The standard LEDs instead indicate in which configuration
you are selecting by pressing
The correspondence is as follows:
LED configuration
button for 5 s.
Pressing the
rest.
Press
(OK).
Meaning (Parameter)
Selecting order of pushbutton
modules
Pushbutton remapping
Automatic procedure for assigning
indoor unit ID
Automatic procedure for assigning
speech unit ID
Lock time
Conversation time
Audio level
Reset factory settings / Restart /
External Memory Reset
Default pushbutton grouping
button (DEL) at this level sets it back to
(OK) to enter the specific configuration.
EN