Preset Setup - Samsung SNC-C7478 Manual Del Usuario

PreSeT SeTuP

PRESET SETUP

PRESET NO.
<EDIT SCENE>
<LABEL>
CLR PRESET
CAM ADJUST
ALARM OUT
BACK
EXIT
• Preset Number [1~128]
If a selected preset is already defined, camera moves
to pre-defined position and preset characteristics
such as Label and Relay Outputs show on monitor. If
a selected preset is not defined, "UNDEFINED" shows
on monitor.
• Edit Preset Scene
Redefine current Preset scene position (i.e. PTZ).
• Edit Preset Label
Edits Label to show on monitor when preset runs.
MAX. 10 alphabets are allowed.
• CLR Preset [CANCEL/OK]
Delete current Preset data
• CAM Adjust [GENERAL/SPECIAL]
WB(White Balance) and AE(Auto Exposure) can be set
up independently for each preset. There are 2 modes,
"General" mode & "Special" mode. The General
mode means that WB or AE can be set up totally and
simultaneously for all presets in "CAMERA SETUP"
menu.
The Special mode means that WB or AE can be set
up independently or separately for each preset in each
preset setup menu. Each Special WB/AE value should
activate correspondingly when camera arrives at each
preset location. During jog operation, General WB/AE
value should be applied.
All Special WB/AE value should not change although
General WB/AE value changes. If "Special'' is
selected, Menu to set WB/AE shows on monitor.
• Alarm out
State of four alarm outputs can be freely controlled in
conjunction with Preset run. The character "-" means
OFF state and the number representing each bit
means ON.
Ex) If it is set to be -23-, Output relay 2, 3 will be ON
and 1, 4 will be OFF, when you run this Preset.
How to use OSD Menu
1
WINDOWS
CANCEL
GENERAL
----
edit Preset Scene
❖
EDIT SCENE - PRESET 1
MOVE TO TARGET POSITION
[NEAR:SELECT / FAR:CANCEL]
 Using joystick, move camera to desired position.
 By pressing Near or eNTer key, save current
PTZ data.
 Press Far key to cancel.
edit Preset label
❖
LABEL - PRESET 1
[█
----------
1234567890
ABCDEFGHIJ
KLMNOPQRST
UVWXYZabcd
efghijklmn
opqrstuvwx
yz<>-/:.
 Edits label to show on monitor when camera
arrives at presets. In Edit Label menu, a reverse
rectangular is cursor. As soon as finishing selecting
alphabet, cursor moves to the next digit.
[
Current Cursor Position
Current Cursor Position
 Using left/right/up/Down of joystick, move to
an appropriate character from the Character set.
To choose that character, press the Near or
eNTer key.
0/0/x1/N
]
OK
CANCEL
]
English –