Dimplex IGFIITEXL BOLD Guía De Instalación Y Uso página 15

Installation
240 V Hardwire Installation (Figure 18)
You will need a 4-wire 240 V supply (L1, L2, Neutral, and Ground).
WARNING: Use the appropriate wire to meet local and national electrical codes for rated power consumption.
1. Connect the black L1 wire from the unit to the L1 wire from the power supply with a wire connector.
2. Connect the red L2 wire from the unit to the L2 wire from the power supply with a wire connector.
3. Connect the white N wire from the unit to the neutral wire from the power supply.
4. Connect the green G wire from the unit to the ground wire from the power supply with a wire connector or attach the
grounding wire.
5. Ensure all wire connections are tight.
Optional Plug Kit (XLFXDPLUG, sold separately)
WARNING: Power cord option is only suitable for 120 V installations.
1. Remove the 3 screws that hold the electrical cover plate.
2. Connect the black L1 wire from the unit to the black wire of the plug kit.
3. Connect the white N wire from the fireplace to the white wire from the plug kit.
4. Connect green G wire from the fireplace to the green wire from the plug kit.
5. Ensure all wire connections are tight.
6. Secure the power cord's pre-installed cover plate using the screws removed when removing the electrical cover plate.
The previously removed electrical cover plate can be disposed of.
WARNING: This heater is not intended for use with an extension cord. Plug the cord directly into an ap propriate
wall receptacle.
WHITE - N
BLACK – L1
RED – L2
GREEN - G
Figure 18
WHITE - N
BLACK – L1
RED – L2
GREEN - G
WHITE – N
120 V
BLACK – L POWER
SUPPLY
(BREAKER
PANEL)
GREEN - G
WHITE – N
240 V
POWER
BLACK – L
SUPPLY
(BREAKER
RED – L2
PANEL)
GREEN - G
15