6 C O M M I S S I O N I N G A N D O P E R AT I O N
6.4 Filling the Filling Chamber
X Unscrew the Cooling Unit from the
Vaporizer by turning it 90° counter-
clockwise.
Filling Chamber partially filled,
with Drip Pad placed on top
X Fill the Filling Chamber completely
with ground plant material up to the
plastic edge.
Excessively
i
material or an overfilled Filling
Chamber makes inhalation more
difficult.
Filling Chamber
properly filled
compressed
plant
To prevent the vaporization materi-
i
al from slipping, place the supplied
Drip Pad over the herbs in a partial-
ly filled Filling Chamber.
X Remove excess plant material
around the Filling Connection.
X Put the Cooling Unit on the Vapor-
izer by turning it 90° clockwise.
6.5 Heating Up
6.5.1 Default Settings
The Vaporizer offers three factory pre-
set temperature levels:
- Basic temperature: 180°C (356°F)
- Booster temperature: + 15°C (27°F)
(in relation to the basic temperature)
corresponds to 195°C (383°F)
- Superbooster temperature: +30°C
(54°F)
(in relation to the basic temperature)
corresponds to 210°C (410°F)
The temperature levels for the
i
base and booster temperature can
be adjusted using a smartphone
and the Storz & Bickel App. See
Chapter 8 "Storz & Bickel App",
page 57.
If a particular temperature level is
i
no longer sufficient, change to the
next level as described below.
6.5.2 Basic Temperature
X Press the orange ON/OFF switch
for at least half a second.
50