Warranty Conditions - Lavor Ares IW Manual De Instrucciones

If the supply cord is damaged, it must be replaced
•
by the manufacturer, its service agent or similary
qualified persons in order to avoid a hazard.
Should extension cables be used, ensure that these
•
lay on dry surfaces and protected against water jets.
Before vacuuming liquids, check the float functions
•
correctly. When vacuuming liquids, and when the
tank is full, a float closes the suction opening, and the
vacuum operation is interrupted. Then switch off the
machine, disconnect the plug and empty the tank.
Regularly clean the water level limiting device (float)
and examine it for signs of damage.
If the machine overturns, it would be recommended
•
to release the trigger gun and then stud up the
machine.
If foam or liquid escape from the appliance, switch off
•
immediately.
The equipment should not be used to pick up
•
water from containers lavatories, tubs, etc.
Aggressive solvents or detergents should not be
•
used.
Service and repairs must be carried out by qualified
•
personnel only. Only use manufacturer original spare
parts for service repair.
The manufacturer cannot be held responsible for any
•
damage/injury caused to persons, animals or property
caused by misuse of the appliance, not in compliance
with manual instructions.
USAGE
(see fig. ②③)
• Be sure that switch is in off position (0) OFF and
connect the machine to a suitable socket.
• The machine must be always kept on horizontal bases,
in a safe and stable way.
• Insert the suitable filters for the proper use.
Never use the appliance without filters .
•
• Use the most suitable accessories for the requested
usage.
• Put switch on (I) ON position in order to start the
machine.
• When job is over, switch off (0) OFF and keep away the
plug from the socket.
• If the appliance is used with especially fine dust
(size below 0.3 µm) the filter supplied will require
cleaning more frequently. For especially demanding
applications, the use of specific filters supplied as an
optional (Hepa) may be necessary.
CARE AND MAINTENANCE (see fig. ④⑤)
The unit is maintenance-free.
T he machine shall be disconnected from its power
•
source, by removing the plug from the socket-outlet,
during cleaning or maintenance
• Clean the exterior part of the machine with a dry
cloth.
• Move the appliance only by catching the carrying
handle located on the motor head.
• Store the appliance and the accessories in a dry safe
place, out of the reach of children.
FILTER CLEANING E2
1- Remove the filter
2- wash tge filter
3- Let the filter drying befor reassemble it
Once the filter has been cleaned, check whether it
•
is suitable for further use. If it has been damaged or
broken, replace it with an original filter.

WARRANTY CONDITIONS

All our machines are subjected to strict tests and are co-
vered against manufacturing defects in accordance with
applicable regulations. The warranty is effective from
the date of purchase.
The following are not included in the warranty: - Parts
subject to normal wear. - Rubber parts, charcoal, filters
and the accessories and optional accessories. - Acciden-
tal damage, caused by transport, neglect or inadequate
treatment, incorrect or improper use and installation
failing - The warranty shall not cover any cleaning ope-
rations to which the operative components may be
subjected, such as clogged nozzles and filter blocked
due to limestones.
DISPOSAL (WEEE)
As the owner of electrical or electronic equipment,
the law (in accordance with the EU Directive 2002/96/EC
of 27 January 2003) prohibits you from disposing of this
product or its electrical / electronic accessories as mu-
nicipal solid waste and obliges you to make use of the
appropriate waste collection facilities.
The product can be disposed of by returning it to the
distributor when a new product is purchased. The new
product must be equivalent to that being disposed of.
7