Airzone Lite Thermostat; Initial Configuration Evaluation - Airzone RADIANT365 Manual De Instrucciones

AIRZONE LITE THERMOSTAT

Zone address
Select the zone associated to the thermostat pulling up the microswitch of the corresponding zone.
Associated outputs
If required, select other control outputs associated to the zone. The address zone will be the one with a lower value.
Other settings
Configure other functionalities of the LITE thermostat from the advanced configuration menu of a Blueface thermostat
(see section Advanced Settings, Zone parameters).
If the association is correct, the LED
red twice, it means the thermostat is out of range.
Remember: If you need to change the zone number, reset the thermostat and start association process.

INITIAL CONFIGURATION EVALUATION

Check the following aspects:
- Opening-closing of the dampers and control outputs: Turn on the system and generate demand in all the zones. Then,
switch off and on all the zones to verify the associated control outputs are correct.
will flash green 5 times. If it flashes red, it means the zone is already occupied. If it flashes
ES
EN
FR
IT
PT
DE
27