Regalo Wall Safe 1163WS Manual De Instrucciones página 4

STEP 5
RECEIVING COMPONENT
OUTER HOUSING
When you are satisfied with the general placement of
your gate, fully tighten the threaded spindle rods
attached to the lower corners of the gate by further
rotating the adjustment wheels. Continue by
tightening the upper threaded spindle rods. As you
tighten the threaded spindle rods, you will notice the
gap between the door frame and the secure slide latch
begin to narrow. In order for the gate to function
properly, stop tightening the upper threaded spindle
rods just before the outer housing of the secure slide
latch and the receiving component touch.
NOTE:
There should be equal spacing among each
of the (4) threaded spindle rods. Make the
appropriate adjustment to ensure you have installed
your gate safely.
Positioning and Attaching Wall Shields™
STEP 1
After you have mounted your gate, and you are
satisfied with its positioning, draw a circle on the
surface of your doorway or opening around the
perimeter of the (4) rubber feet.
Next, completely remove the gate from the
opening by loosening each of the (4) threaded
spindle rods to depressurize the gate.
Operating the Door Latch
STEP 1
Push one or both of the circular buttons on
the secure slide latch while simultaneously
pulling back. These two actions combined
will disengage the lock and allow the gate to
open freely.
Push or pull to open the gate door. To close,
simply push or pull the door back into its
original position. The secure slide latch will
re-engage automatically and lock the door into
its closed position.
NOTE:
If your secure slide latch is not properly
engaging with the receiving component, ensure
that your gate is level, mounted properly, and
that you have not over-tightened the threaded
spindle rods.
STEP 2
With gate fully removed, you can now use the
circles you marked during Step 1 as guides for
screwing in your (4) wall shields™ (D). Center
each of the wall shields™ within the guide circles
and use the provided self-tapping screws (E) to
fasten them in place via the hole through the
center of each wall shield™.
STEP 2
LOCKING SLIDE
CIRCULAR
BUTTON
BASE LOCK
At the bottom of the gate door, rotate
the base lock to the horizontal position.
To allow the door to swing open in only
one direction rotate the base lock on one
side. To allow the door to swing open in
both directions, rotate the base lock on
both sides.
NOTE:
occupied by the child.
STEP 3
Reinstall your gate in the doorway or opening
according to the instructions, using the newly
installed wall cups as anchoring points for the
(4) threaded spindle rods.
Place lock down on side