Declaration Of Conformity; Dust/Chip Extraction; Starting Operation - Berner BACS-1 10,8V LI Manual Original

OBJ_BUCH-175-003.book Page 14 Wednesday, September 22, 2010 3:44 PM

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in con-
formity with the following standards or standardization
documents: EN 60745 according to the provisions of
the directives 2004/108/EC, 2006/42/EC.
Technical file at:
Berner AG, Bernerstraße 6, D-74653 Künzelsau
Jörn Werner Ulrich Lindner
CEO COO
07.07.2010, Berner AG; Bernerstraße 6;
D-74653 Künzelsau
Assembly
Battery Charging (see figure A)
Note: The battery is supplied partially charged. To
ensure full capacity of the battery, completely charge
the battery in the battery charger before using your
power tool for the first time.
The lithium ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
The lithium ion battery is protected against deep dis-
charging by the "Electronic Cell Protection (ECP)".
When the battery is empty, the machine is switched
off by means of a protective circuit: The inserted tool
no longer rotates.
Do not continue to press the
WARNING
On/Off
machine has been automatically switched off.
The battery can be damaged.
To remove the battery 7 press the unlocking buttons
6 and pull out the battery downwards. Do not exert
any force.
The battery is equipped with a NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery
service life is achieved in this manner.
Observe the notes for disposal.
14 | English
Changing the Tool (see figure B)
¢ Before any work on the machine (e. g., main-
Inserting
Pull the locking sleeve 3 toward the front and then
push the insert tool to the stop into the tool holder 2.
The insert tool is automatically locked.
Removing
Pull the locking sleeve 3 forward and remove the
insert tool.

Dust/Chip Extraction

¢ Dusts from materials such as lead-containing coat-
switch after the
Operation

Starting Operation

Inserting the Battery
¢ Use only original Berner lithium ion batteries
Note: Use of batteries not suitable for the machine
can lead to malfunctions of or cause damage to the
power tool.
Set the rotational direction switch 8 to the centre posi-
tion in order to avoid unintentional starting. Insert the
charged battery 7 into the handle so that it can be felt
to engage and faces flush against the handle.
tenance, tool change, etc.) as well as during
transport and storage, set the rotational
direction switch to the centre position. Unin-
tentional actuation of the On/Off switch can lead
to injuries.
ings, some wood types, minerals and metal can be
harmful to one's health. Touching or breathing-in
the dusts can cause allergic reactions and/or lead
to respiratory infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are con-
sidered as carcinogenic, especially in connection
with wood-treatment additives (chromate, wood
preservative). Materials containing asbestos may
only be worked by specialists.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class res-
pirator.
Observe the relevant regulations in your country
for the materials to be worked.
with the voltage listed on the nameplate of
your power tool. Using other batteries can lead
to injuries and pose a fire hazard.
1 609 929 U97 • 22.9.10