Tabla de contenido
Idiomas disponibles
Idiomas disponibles
F
P
S
OAM
ANEL
TORAGE
FOAM PANEL STORAGE
If foam walk-in panels require storage at the job site prior to installation, the following steps must be taken to protect
the panels against both staining from moisture and sunlight, and denting by workers and traffic.
Whenever possible, the panels should be stored indoors, and should remain in the crating pallet they were originally
shipped in. If the panels were uncrated as they were unloaded from the delivery truck, and they are being stored
indoors, they should be stored vertically on skids with spacers between the panels.
When storing panels in a vertical position, always place the female rail (grooved) edge down (see illustration
below.) This method of storing panels will provide proper ventilation, permit drain-off of condensation moisture and
protect panels against the formation of white rust stains.
If the panels must be stored outdoors, follow the same procedure as indicated for indoor storage WITH THIS
ADDITION: Cover the panels completely with an opaque polyethylene water-proof material to protect against rain,
snow, heat and sunlight.
The illustration below shows the method for storage outdoors when panels are not left in palletized crates.
6
© 2008 Nor-Lake 4/08 PN 121428
Tabla de contenido
