Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DOOR GASKET REPLACEMENT
1. The magnetic door gasket consists of a cavity containing the magnetic
strip, a bellows cavity that permits the gasket to conform to irregular surfaces,
and a base section that features a dart- shaped projection that serves as the
attachment means when it is forced into the slot in the door breaker.
2. To remove the original magnetic gasket
assembly, grasp the gasket at one of the
corners and pull the dart-shaped projection
out of the retainer slot in the door breaker.
Pull slowly and examine your progress to
avoid tearing the projection which will then
remain in the retainer slot.
3. Remove the entire gasket assembly and
examine the retainer slot to make sure that
it is free of gasket material or other debris.
4. Starting at one corner, insert the dart-shaped projection of the replacement
gasket into the retainer slot and, using a rubber mallet, drive the dart into the
retainer slot. HINT: Cover the face of the rubber mallet with masking tape
to prevent smudging the gasket. Attach only about two inches (2") of the
gasket in each direction away from the corner.
5. Use the same procedure as in Step 4 at the remaining corners and also
midway between the corners on the long sides of the door.
6. Using the rubber mallet, drive the dart
into the retainer slot working from the
center of each side toward the corners.
7. Lift the gasket base on the outer edge
of the gasket and examine the gasket to
determine if the dart is engaged by the
retainer slot around the entire perimeter of
the door, except where the sweep gasket
is attached. If the dart has failed to engage
in some areas, a small, slotted screwdriver
blade can be used to tuck the dart into the
slot.
8. Replace the door assembly. Simply reverse the instructions in the "Door
Assembly Removal" section.
21
W
-I
M
ALK
N
AINTENANCE
© 2008 Nor-Lake 4/08 PN 121428
Tabla de contenido
