Installation Manual For Bmk Control Module- Wall Mounting - Wolf BMK Instrucciones De Montaje

The procedure for the wall mounting of the control module is as follows:
(A)
(B)
(C)
1. Mount the wall base on the wall using the screws (A)
2. Install the cables and fasten with the cord grip (B) provided
3. Feed the ends of the cables through the opening (C) in the rear panel of the control module
4. Fasten the rear panel to the wall base using the screws (D)
5. Connect the cables as follows:
VL / GND
Supply voltage via KLM controller
(see circuit diagram)
6. Fasten the control unit to the rear panel using the screws (E)
7. Mount the cover plate (F) (latches)
Technical data
Degree of protection
Operating conditions
maximum power consumption
3063018_201112
Installation manual for BMK control module
GB
- wall mounting
(D)
(E)
(F)
+
Data bus (pLAN)
Tx+/Rx+
IP 40
-20 - 60 °C;
90 % RH non-condensing
0,8 W
-
Data bus (pLAN)
Tx-/Rx-
3