Precautions Against Kickback - Ryobi OPS-1820 Manual De Utilización

GB
F D E I
Following this rule will reduce the risk of shock, fire,
or serious injury.
Do not force the pole pruner. Use the correct tool for
■
your application. The correct tool will do the job better
and safer at the rate for which it is designed.
Do not overreach. Keep proper footing and balance at
■
all times. Proper footing and balance enables better
control of the pole pruner in unexpected situation.
Do not use on a ladder or unstable support.
Secure long hair so it can not become entangled in
■
moving parts or air intake.
Do not operate this unit when you are tired, ill, or under
■
the influence of alcohol, drugs, or medication.
Do not operate in poor lighting.
■
Never let anyone use your unit who has not received
■
adequate instructions in the unit's proper use.
This applies to rentals as well as private owned units.
Keep the handles dry and clean.
■
Before you start the unit, make sure the blade is not
■
contacting any object.
Stop the unit, remove the battery pack, and make sure
■
the blade has stopped before setting the unit down.
To protect yourself from electrocution, do not operate
■
within 10 m of overhead electrical lines. See Figure 1.
To protect yourself from falling branches, do not stand
■
directly under the branch or limb being cut. This unit
should not be held at an angle over 60° from ground
level. See Figure 2.
Consider work area environment. Do not expose
■
power tools to rain. Do not use power tools in damp or
wet locations. Keep work area lit. Do not use power
tools where there is risk to cause fire or explosion.
Store battery or idle tools. When not in use, tools and
■
batteries should be stored separately in dry, high or
locked up place out of reach of children. Ensure that
battery terminals cannot be shorted by other metal
parts such as screws, nails, etc.
Disconnect tools where the design permits. Disconnect
■
the tool from its battery pack when not in use, before
service and when changing accessories such as
blades, bits and cutters.
Remove adjusting keys and wrenches. Form the habit
■
of checking to see that keys and adjusting wrenches
are removed from the tool before turning it on.
Avoid unintentional starting. Do not carry the tool with
■
a finger on the switch.
Stay alert. Watch what you are doing. Use common
■
sense. Do not operate tool when you are tired.
Have your tool repaired by a qualified person.
■
This tool is in accordance with the relevant safety
requirements. Repairs should only be carried out by
P NL S DK N FIN GR HU CZ RU RO PL SLO HR TR EST LT
English
qualified persons using original spare parts, otherwise
this may result in considerable danger to the user.
WARNING
Use only the manufacturer's replacement parts.
Failure to do so may cause poor performance,
possible injury and may void your warranty

PRECAUTIONS AGAINST KICKBACK

Kickback is a dangerous reaction that can lead to
serious injury.
Keep a good firm grip on the unit with both hands
■
when operating the unit. Place your right hand on the
rear handle and the left hand on the front handle.
A firm grip will help you reduce kickback and maintain
control of the unit.
Make sure that the area in which you are cutting is
■
free from obstructions. Do not let the blade come in
contact with any obstruction while operating the unit.
Always cut with the unit at full speed. Fully squeeze
■
the trigger and maintain a steady cutting speed.
Use only the replacement blade specified for your unit.
■
BATTERY TOOL USE AND CARE
Ensure the switch is in the off position before
■
inserting battery pack. Inserting the battery pack into
power tools that have the switch on invites accidents.
Recharge only with the charger specified by the
■
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used
with another battery pack.
Use power tools only with specifically designated
■
battery packs. Use of any other battery packs may
create a risk of injury and fire.
When battery pack is not in use, keep it away from
■
other metal objects like paper clips, coins, keys, nails,
screws, or other small metal objects that can make a
connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
Under abusive conditions, liquid may be ejected from
■
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid cotntacts eyes,
additionally seek medical help. Liquid ejected from
the battery may cause irritation or burns.
SAVE THESE INSTRUCTIONS. REFER TO THEM
FREQUENTLY AND USE THEM TO INSTRUCT
OTHERS WHO MAY USE THIS UNIT. IF YOU LOAN
SOMEONE THIS UNIT, LOAN THEM THESE
INSTRUCTIONS ALSO.
9
LV SK BG