clage M-O Serie Manual De Instrucciones página 22

M 3...7-O
Installation
EN
Fig. 6: "Installation with SMB tap"
2. Push the collar on to the ½ inch water connection of the tap.
3. Screw the tap on to the ½ inch water connection and seal with thread seal tape. The water
connections must be horizontal.
4. Insert seals into the ⅜ inch connections of the tap.
5. Hook the instantaneous water heater into the metal wall bracket from above and position it
on the ⅜ inch connections of the tap.
6. Tighten the union nuts alternately until they are hand-tight. Use a spanner to hold the
instantaneous water heater water connections steady as you do so.
7. Insert the swivel outlet into the tap body from below and screw tight.
8. After installation, check that all connections are tight.
5
4
3
2
7
22