Elapsed Time Key; Locking The Controls; Clean Lock Function; Ics Function - De Dietrich DPI7684XT Guía De Utilización

2
•
USE
- Set the time with touchpad
flashes in the display (2.7.5).
- At the end of your adjustment "t" be-
comes becomes fixed and the count be-
gins.
Note:
You can stop a count in progress by
keeping your finger on the touchpad of
the selection on the display.

2.8 ELAPSED TIME key

This function displays the time since
the power setting was last changed for
a selected cooking zone.To use this
function, press the
time flashes in the selected zone's
timer display (2.8.1).
If you want cooking to end within a
specific time, press the
then, within 5 seconds, press + on the
timer to increase the desired cooking
time. The elapsed time is displayed
fixed for 3 seconds and then the
remaining time is displayed. A beep
sounds to confirm your choice.
This function is available with or
without the timer function.
Note: if the timer is showing a time, it is
not possible to change it within 5
seconds of pressing
seconds, the cooking time can be
changed.

2.9 LOCKING THE CONTROLS

Child safety lock
Your hob has a child safety device
which locks the controls when the hob
is not in use or during cooking (to
maintain the current settings). For
safety reasons, only the stop key and
the zone selection keys are still active
g
. A "t"
i
. The elapsed
i
key and
i
. After 5
27
and allow the hob or a cooking zone to
be switched off.
Locking
b
Press key (cadenas), until the "bloc"
locking symbol appears in one of the
displays and a beep confirms the
operation (2.9.1).
Table locked in operation
The display of cooking zones in
operation alternately indicates power
and the locking symbol .
When you press the power or timer keys
for the zones which are «on»:
«bloc» appears for 2 seconds and then
switches off.
Unlocking
b
Press key until the "bloc" locking
symbol disappears from the display and
a beep confirms the operation.

CLEAN LOCK function

This function locks the hob off while it is
being cleaned.
To activate Clean lock:
Give a short press on key
A beep sounds and the «bloc» symbol
flashes in the display.
After a predefined time, the lock will
automatically disengage. Two beeps
sound and «bloc» switches off. You can
stop the Clean Lock at any moment by
pressing and holding touchkey

2.10 ICS FUNCTION

Intelligent Cooking System
This function optimises the choice of
cooking zone for the diameter of
cookware used.
Proceed as follows:
b
(padlock).
b
.