Tabla de contenido
Call waiting:
When you hear a camp-on tone during a
conversation, you can answer the waiting
call by pressing the Call waiting key
The first call will be put on hold.
If you want to return to the held call, press
the Call waiting key
manner, you can toggle between both
parties as often as you want. You can end
the conversation with either party by
pressing the Disconnect key
the last conversation, simply replace the
handset.
Consultation call:
At any time during a conversation, you can
make a consultation call. Press the FLASH
key
until you hear the dial tone Then,
dial the desired number to initiate the
consultation call.
Once the consultation call has been
completed, you can either press the Call
waiting key
to toggle between the two
parties or the Disconnect key
your conversation with one of the parties
and return to the held party.
Conference:
The conference feature allows you to set up
a three-party conference. First, you must
set up two connections using the Call
waiting
or
Consultation
described above. Then, you can press the
Conference key
the conference.
Mailbox:
The Mailbox feature allows messages to be
stored for subsequent retrieval. This feature
works by assigning an access code to the
Mailbox key
. This is done by following
the same procedure that is used for storing
numbers in one-touch memories (see
Storing phone numbers in memories on
page 5).
again. In this
. To end
to end
call
features
to add the third party to
Operator code
You can program this telephone with the
operator code of your preference. The
.
operator code is assigned to the Operator
key
by following the same procedure
that is used for storing numbers in one-
touch memories (see
numbers in memories on page 5).
Note:
The operator code is only valid in countries
where this feature is available.
9
Storing phone
Tabla de contenido
