Electrical Safety; Package Contents; Overview (Fig. A) - BLACK&DECKER KC9036 Manual De Instrucciones

Do not probe the charger.
The charger is intended for
indoor use only.

ELECTRICAL SAFETY

Your charger has been designed
for a specific mains voltage.
Always check that the mains
voltage corresponds to the
voltage on the rating plate.
Your charger is double
insulated in accordance with
EN 60335; therefore no
earth wire is required.
Never attempt to replace
the charger unit with a
regular mains plug.

PACKAGE CONTENTS

The pack contains:
1 Cordless screwdriver
1 Double-ended screwdriver bit
1 Charger
1 Instruction manual
Carefully unpack all parts.
Please note that additional
items may be found in the
carton, depending on the
letter suffix following the
catalogue number of your
tool.

OVERVIEW (fig. A)

1. On/off switch with forward/
reverse function
2. Spindle lock collar (KC9036)
2. Torque adjustment collar
(KC9039)
3. Bit holder
4. Handle adjustment button
5. Handle
6. Battery cover
ASSEMBLY
Before assembly, engage
the spindle lock as
described below.
KC9036EUR.PM65
E N G L I S H
Fitting and removing a
screwdriver bit (fig. B)
To fit a screwdriver bit (7),
push it into the bit holder
until it locates.
To remove a screwdriver bit,
pull it straight from the bit
holder.
Fitting and removing a bit tip
using the bit tip holder (fig. B)
To fit the bit tip holder (8),
push it into the bit holder
until it locates.
To fit a bit tip (9), insert it into
the bit tip holder (8).
To remove a bit tip, pull it
from the bit tip holder.
To remove the bit tip holder,
pull it straight from the bit
holder.
USE
Let the tool work at its own
pace. Do not overload.
Charging the battery (fig. C)
The battery needs to be charged
before first use and whenever it
fails to produce sufficient power
on jobs that were easily done
before. When charging the
battery for the first time, or after
prolonged storage, it will only
accept an 80% charge. After
several charge and discharge
cycles, the battery will attain full
capacity. The battery may
become warm while charging;
this is normal and does not
indicate a problem.
Do not charge the battery at
ambient temperatures
below 4 °C or above 40 °C.
Recommended charging
temperature: approx. 24 °C.
9
9
25-06-2001, 14:53