Dispensing Hot Water; Al - Aep" Versions; Sae - Display" Versions; Dispensing With The Automatic Steam Wand - Astoria AL Manual De Uso Y Mantenimiento. Instrucciones Para El Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 123

6.7 Dispensing hot water

Danger of scalding. Do not direct hot water to-
wards hands or other parts of the body. Do not
touch the hot water nozzle with bare hands; use
the appropriate PPE.
The hot water dispensing method is different for each ma-
chine type; therefore, the instructions specific to the model
being used must be followed.
6.7.1

"AL - AEP" versions

• Place the jug under the hot water nozzle.
• Rotate the valve knob anticlockwise.
• The quantity of hot water dispensed will be proportional
to how open the valve is.
• When the desired quantity of water has been dispensed,
turn the valve knob clockwise to stop dispensing.
50
216
of
6.7.2

"SAE - DISPLAY" versions

DISPENSING HOT WATER
• Place the jug under the hot water nozzle.
• Press the water button
dispensed.
• The machine dispenses a programmed quantity of hot
water; to stop it from dispensing ahead of time, press the
hot water dispensing button
button.
PROGRAMMING THE HOT WATER
The machine is programmed by default. Should the hot water
doses need to be modified, proceed as follows:
• Place the jug under the hot water nozzle.
• Press the
button for at least 5 seconds, until all the
dose button LEDs are lit.
• Press the hot water dispensing button
ing.
• When the desired amount of water has been reached,
press the
button again to confirm the dose.
• When the programming is complete, press the
ton until all of the LEDs on the push-button panel go off.
6.8 Dispensing with the automatic
steam wand

Tips regarding its use

6.8.1
• Only froth the amount of milk that you intend to use; once
heated, the milk will have to be completely poured out of
the jug and cannot be reheated.
• The automatic steam wand only guarantees an accuracy
of ± 3°C between the set temperature and the actual milk
temperature, if the starting milk temperature is 4°C.
• As the steam automatically stops dispensing when the set
milk temperature is reached, only fill the jug half way in
order to prevent the milk froth from spilling out.
• Use a suitably-sized jug for the amount of milk that requires
frothing (approx. 200 ml is recommended) and make sure
that it is circular and not conical (see the image).
and wait for the hot water to be
again or press the
to start dispens-
USER manual
but-
Tabla de contenido
loading

Este manual también es adecuado para:

AepSaeDisplay

Tabla de contenido