Tabla de contenido
Idiomas disponibles
Idiomas disponibles
does not move freely and close instantly.
Never clamp or tie the blade guard into the
open position.
4.
Do not perform any operation freehand. The
workpiece must be secured firmly against the
turn base and guide fence with a vise during
all operations. Never use your hand to secure
the workpiece.
5.
Never reach around saw blade.
6.
Turn off tool and wait for saw blade to stop
before
moving
settings.
7.
Remove battery from tool before changing
blade or servicing.
8.
To reduce the risk of injury, return carriage to
the full rear position after each crosscut
operation.
9.
Always secure all moving portions before
carrying the tool.
10. Stopper pin which locks the cutter head down
is for carrying and storage purposes only and
not for any cutting operations.
11.
Be aware that this tool is always in an
operating condition, because it does not have
to be plugged into an electrical outlet.
12. Do not use the tool in the presence of
flammable liquids or gases. The electrical
operation of the tool could create an explosion
and fire when exposed to flammable liquids or
gases.
13. Check the blade carefully for cracks or
damage before operation. Replace cracked or
damaged blade immediately. Gum and wood
pitch hardened on blades slows saw and
increases potential for kickback. Keep blade clean
by first removing it from tool, then cleaning it with
gum and pitch remover, hot water or kerosene.
Never use gasoline to clean blade.
14. While making a slide cut, KICKBACK can
occur. KICKBACK occurs when the blade
binds in the workpiece during a cutting
operation and the saw blade is driven rapidly
towards the operator. Loss of control and
serious personal injury can result. If blade
begins to bind during a cutting operation, do
not continue to cut and release switch
immediately.
15. Use only flanges specified for this tool.
16. Be careful not to damage the arbor, flanges
(especially the installing surface) or bolt.
Damage to these parts could result in blade
breakage.
17. Make sure that the turn base is properly
secured so it will not move during operation.
Use the holes in the base to fasten the saw to
workpiece
or
changing
a stable work platform or bench. NEVER use
tool where operator positioning would be
awkward.
18. For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
19. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
20. Make sure the shaft lock is released before the
switch is turned on.
21. Be sure that the blade does not contact the
turn base in the lowest position.
22. Hold the handle firmly. Be aware that the saw
moves up or down slightly during start-up and
stopping.
23. Make sure the blade is not contacting the
workpiece before the switch is turned on.
24. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced blade.
25. Wait until the blade attains full speed before
cutting.
26. Stop operation immediately if you notice
anything abnormal.
27. Do not attempt to lock the trigger in the "ON"
position.
28. Be alert at all times, especially during
repetitive, monotonous operations. Do not be
lulled into a false sense of security. Blades are
extremely unforgiving.
29. Always use accessories recommended in this
manual. Use of improper accessories such as
abrasive wheels may cause an injury.
30. NEVER hold workpiece on right side of blade
with left hand or vice versa. This is called
cross-armed cutting and exposes user to risk
of SERIOUS PERSONAL INJURY as shown in
the figure. ALWAYS use vise to secure
workpiece.
000030
4
Tabla de contenido
