Makita BHR200 Manual De Instrucciones página 8

ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Side grip
1
The side grip swings around to either side, allowing easy
handling of the tool in any position. Loosen the side grip
by turning it counterclockwise, swing it to the desired
position and then tighten it by turning clockwise.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck
lubrication assures smooth action and longer service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before installing
the bit.
2
1
Insert the bit into the tool. Turn the bit and push it in until
it engages.
1
2
003141
1. Side grip
003150
1. Bit shank
2. Bit grease
003157
1. Bit
2. Chuck cover
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
Bit angle
(when chipping, scaling or demolishing)
1
To change the bit angle, depress the lock button and
rotate the change lever so that the pointer points to the
"O" symbol. Turn the bit to the desired angle.
Depress the lock button and rotate the change lever so
that the pointer points to the that the bit is securely held in place by turning it slightly.
1
8
003166
003170
2 1. Change lever
2. O symbol
symbol. Then make sure
003174
1. Change lever