Electric Brake; Torque Limiter - Makita BHR200 Manual De Instrucciones

Electric brake

This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after switch trigger
release, have tool serviced at a Makita service center.
Reversing switch action
1
A
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for counter-
clockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
CAUTION:
• Always check the direction of rotation before
operation.
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
• When not operating the tool, always set the
reversing switch lever to the neutral position.
Selecting the action mode
Rotation with hammering
1
For drilling in concrete, masonry, etc., depress the lock
button and rotate the change lever so that the pointer
points to the symbol. Use a tungsten-carbide tipped
bit.
003113
1. Reversing
switch lever
B
003128
1. Rotation with
2
hammering
2. Lock button
3. Pointer
4. Change lever
3
4
Rotation only
1
For drilling in wood, metal or plastic materials, depress
the lock button and rotate the change lever so that the
pointer points to the
wood bit.
Hammering only
2
For chipping, scaling or demolition operations, depress
the lock button and rotate the change lever so that the
pointer points to the
chisel, scaling chisel, etc.
CAUTION:
• Do not rotate the change lever when the tool is
running. The tool will be damaged.
• To avoid rapid wear on the mode change
mechanism, be sure that the change lever is always
positively located in one of the three action mode
positions.

Torque limiter

The torque limiter will actuate when a certain torque level
is reached. The motor will disengage from the output
shaft. When this happens, the bit will stop turning.
CAUTION:
• As soon as the torque limiter actuates, switch off
the tool immediately. This will help prevent
premature wear of the tool.
7
003131
1. Rotation only
2. Pointer
2
symbol. Use a twist drill bit or
003133
1
1. Hammering only
2. Pointer
symbol. Use a bull point, cold