Hanger (Suspension Point) - Makita DUR182L Manual De Instrucciones

1
2
3
4
013817
Insert the hex wrench through the hole on the protector
cover and the motor housing and rotate the receive
washer until it is locked with the hex wrench. Mount the
metal guard, the nylon cutting head onto the threaded
spindle directly and
counterclockwise. Remove the hex wrench.
To remove the nylon cutting head, turn the nylon cutting
head clockwise while holding the receive washer with
the hex wrench.
CAUTION:
If during operation the nylon cutting head
•
accidentally impacts a rock or hard object the
trimmer should be stopped and inspected for
any damage. If the nylon cutting head is
damaged it should be replaced immediately.
Use of a damaged nylon cutting head could result
in serious personal injury.
OPERATION
Correct handling of tool
Attachment of shoulder harness
1
2
014156
Put the shoulder harness on. Then connect the buckles
on both the hook and the harness. Be sure that the
buckles click and lock completely in place.
1. Nylon cutting
head
2. Metal guard
3. Receive washer
4. Hex wrench
tighten it by turning
1. Buckle
2. Hook
For Model DUR183L
014165
When the cap is not in use, hang it on the hook.
Detachment
it
014157
The buckle is provided with a means of quick release.
Simply squeeze the sides and the buckle to release the
tool.
WARNING:
Be extremely careful to maintain control of the
•
trimmer at all times. Do not allow the trimmer
to be deflected toward you or anyone in the
work vicinity. Failure to keep control of the
trimmer could result in serious injury to the
bystander and the operator.
Adjustment of the hanger position and shoulder
harness
014164
To change the hanger position, loosen the hex bolt on
the hanger with the supplied wrench. Then move the
hanger.
After adjusting the hanger position, tighten the hex bolt
with the wrench securely.
12
1. Cap
1
1. Buckle
1
1. Hex bolt
1