Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Loosen the collet nut and insert the wheel point into the
collet nut. Use the smaller wrench to hold the spindle and
the larger one to tighten the collet nut securely.
The wheel point should not be mounted more than 10
mm (3/8") from the collet nut. Exceeding this distance
could cause vibration or a broken shaft.
To remove the wheel point, follow the installation proce-
dure in reverse.
10 mm (3/8") Max.
CAUTION:
•
A 1/4" collet cone is provided as standard equip-
ment. Use an optional collet cone 1/8" to install a 1/
8" shank wheel point.
OPERATION
Turn the tool on without the wheel point making any con-
tact with the workpiece and wait until the wheel point
attains full speed. Then apply the wheel point to the
workpiece gently. To obtain a good finish, move the tool
in the leftward direction slowly.
CAUTION:
•
Apply light pressure on the tool. Excessive pres-
sure on the tool will only cause a poor finish and
overloading of the motor.
Dressing wheel point
1
003494
003496
003498
1. Dressing stone
When the wheel point becomes "loaded" with various bits
and particles, you should dress the wheel point with the
dressing stone.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
•
These accessories or attachments are recom-
mended for use with your Makita tool specified in
this manual. The use of any other accessories or
attachments might present a risk of injury to per-
sons. Only use accessory or attachment for its
stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
5
001145
1. Limit mark
1
003489
1. Brush holder
1
cap
2. Screwdriver
2
Tabla de contenido
