Duress Access Control; Partial Alarm Setting; Terminating A Triggered Alarm - jablotron JA-103K Manual Del Usuario

Ocultar thumbs Ver también para JA-103K:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 70

2.1.2.3. DURESS ACCESS CONTROL

This function provides unsetting of the system in a special mode. The system seemingly unsets,
however it triggers a silent panic alarm, which is then reported to selected users (including ARC).
Unsetting under duress is executed by adding 1 to the last number in a valid code.
Example for a code with the prefi x:
Example for a code without the prefi x:

2.1.2.4. PARTIAL ALARM SETTING

1. Authorize yourself using
the keypad (enter a code or hold a
card or a tag up to the reader). The
green backlit indication button will
start fl ashing.
The system can also be confi gured to be partially set which allows guarding only by certain detectors
in a section.
detectors inside a house do not react to anything.
To fully set the premises in which partial setting is enabled, the button to set the system has to be
pressed twice. After the button is pressed once it fl ashes yellow, when it is pressed a second time it fl
ashes red. If the system is partially set – indicated by a continuous yellow light – the entire system can
be fully set by authorization and pressing the yellow button. Once the button is pressed, the system will
be fully set and the button turns red.

2.1.2.5. TERMINATING A TRIGGERED ALARM

1. Authorize
yourself using the keypad
(enter a code, hold a tag
up to the reader).
32
Example: At night, it is possible to set the door and window detectors only, while motion
2. Press
the left segment button
of the section where the
alarm has been triggered.
Valid code: 2*9999
Valid code: *9999
2. Press the right segment
button
of the selected section.
3. Unsetting is
fi nished
and sirens are silenced.
The green fl ashing button
indicates unsetting of the
particular section. The
red fl ashing light indicates
alarm memory.
Code for unsetting under duress: 2*9990
Code for unsetting under duress: 9990
3. The command
is executed,
and the segment button turns yellow
to indicate a partially set section.
4. Authorize
yourslef and press the
green button again to
cancel the alarm memory
indication.
5. The segment
Indicates the unset section
with a continuously lit up
green button.
Tabla de contenido
loading

Este manual también es adecuado para:

Ja-107k100+

Tabla de contenido