Electric Connection Rules - Ugur USD 1045 BK Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
C- INSTALLATION OF YOUR DEEP FREEZER
Installation
Before positioning, remove and disassemble all packaging materials and bottom wooden pallet of the freezer. (It
may be necessary to lift the cooler for removing the bottom pallet).
Insert the spare parts inside your product according to the installation instructions. Only use genuine Uğur
spare parts.
Inauthentic spare parts may constitute danger for you and damage your product.
Place the product anywhere you desire. Consider the placement rules written in the manual while position-
ing the product.
Balance your product in width and in depth by means of a water gauge. Perform balancing operation by
using adjustable feet at the bottom front of your cooler. (Picture 18)
In models with wheels (optional), wheel brake (optional) must be locked or if there is no wheel brake, it
must be guaranteed that the device will not move after the positioning of the product.
EN
PICTURE 18
44
C- INSTALLATION OF YOUR DEEP FREEZER

Electric Connection Rules

The product will start when you insert the plug into the outlet as shown in picture 19.
WARNING!
It is forbidden to insert the plug into multiple socket and to use extension cord. (Picture 20)
There is no separate on-off switch on your product.
Do not contact the cables of your product, which are connected to the mains, to hot surfaces.
The outlet you will use must be grounded. Furthermore, the outlet to be used must have the resistance of
at least 10-16 A and be protected with a suitable fuse. Definitely take assistance from our technical service
or a competent electrician with regards to the fuse that should be present on the mains where the outlet is
connected.
Mains voltage and frequency must be same with the value written on the label inside your product. If your
mains voltage is extremely below or above the value indicated, definitely supply demanded voltage by us-
ing a voltage regulator. You can get assistance from an expert electrician with this regard.
Do not place your product's cord onto passageways. This may cause you to get injured and damage your
cooler. (Picture 21)
PICTURE 19
PICTURE 20
PICTURE 21
45
EN
Tabla de contenido
loading

Tabla de contenido