Transportation Of Your Product; Internal Cleaning; External Cleaning - Ugur USD 1045 BK Manual De Instrucciones

E- CLEANING, MAINTENANCE AND TRANSPORTATION OF YOUR
DEEP FREEZER
CLEANING
Cleaning of your device is composed of two stages, which are the internal cleaning and external cleaning.
Following warnings must certainly be abided before start cleaning.
CAUTION!
Unplug your deep freezer before every cleaning.
Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
Never use abrasive and scratching substances (flammable and sparkling, solvent like gasoline, thinner, acid) as
cleaning agents. Never use flowing and pressurized water for cleaning. (Picture 30-31)
Do not wash inside and outside of your product. It may damage your product and cause electrical shock. (Picture 32)
If the place where your product is installed is a wet and humid place, external dye of your product may be damaged.
It must be moved another place free of damp and humidity
PICTURE 30
EN

Internal cleaning

Transfer the foodstuff inside your product to a convenient place.
Before the internal cleaning, wait until the temperature of the internal parts of your product reaches to the ambient
temperature.
Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
Remove the accessories from inside.
Perform cleaning with a soft cotton cloth and warm soapy water or by using the cleaning agents recommended by
Uğur Soğutma A.Ş.
Dry with a dry cotton cloth. Products, which are not dried, may darken in time.
Make sure that no wet or humid area is left in the internal section after cleaning.
You can reload your product three (3) hours after running your product as stated in this manual.

External cleaning

Clean with a cotton cloth and warm soapy water.
Prevent penetration of cleaning water into the front control panel and light-
ing section while cleaning. (Picture 33)
Clean the door gasket by using clean soapy water only.
Maintenance
This product does not require periodical maintenance.
SUGGESTION
You can use Uğur branded cleaning agents, which you can get from Authorized Uğur Services for
internal and external cleaning of your device.
PICTURE 31 PICTURE 32
PICTURE 33
52
E- CLEANING, MAINTENANCE AND TRANSPORTATION OF YOUR
DEEP FREEZER

Transportation of your product

Unplug your product from the grounded outlet.
Carry out defrost operation.
Carry your product at normal using position. Do not carry horizontally, vertically, tilted or with the door open.
Protect your product from the impacts while carrying. Do not carry your product when it is plugged in or full.
In order not to cause any accident or for preventing the product to get damaged by falling or sliding, secure
your product to the vehicle during the transportation.
NOTE
Pay attention to the following considerations if you do not use your product for reasons such as
vacation, trip etc.
If you do not use it for a short time:
Leave your product in operating state.
If you do not use it for long time and want to shut it down:
Consume the foodstuff inside your product and empty it.
Unplug the power cord from the outlet. (Picture 34)
Apply defrost and internal cleaning steps in this manual.
Dry inside of the product thoroughly. Darkening may occur in the product which is not dried. (Pic-
ture 35)
Leave the product door open. (Picture 36)
PICTURE 34 PICTURE 35 PICTURE 36
53
EN