Ugur USD 1045 BK Manual De Instrucciones página 24

D- USING YOUR DEEP FREEZER
Start-up
WARNING!
• Bu This operating manual applies for various device models. Hardware scopes of the models may vary.
There may be differences in the pictures.
• Clean inside and all accessories of your product before the first start up. (see page 21).
• If your product has been shaken so much during the transportation and positioning, wait for one (1) hour
without running your freezer. Thus, the compressor oil, which may enter into the system, will return back.
You may damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which has been
installed according to the regulations. (Picture 22)
You will hear a slight sound from the compressor when your product is
running.
Green and red check lamps will light upon turning on your product.
Upon first operation of your product, press fast (super) freezing button
in yellow colour. Thus your freezer will make deeper freezing.
PICTURE 22
EN
Control Panel (Optional)
Indicators and controls on the control panel of your products are shown in Picture 23 below.
PICTURE 23
Alternative control panels
1) Thermostat setting button for setting the internal temperature of your product: When you put the thermostat setting to
"S" position or press the super button for the first time, you will run fast (super) freezing function that you can use during the
initial operation or when you want a faster freezing.
2) Fast (super) freezing lamp (yellow light) that you can use during the initial operation or when you want a faster freezing.
3) Alarm indicator that warns you with red light when internal temperature of your product reaches to critical levels.
4) Energy lamp showing your product is powered (Green light).
Alterna-
tive control
46 5
3
2
panels
1 7
8
0
9
MAX
I
0
4
SUPERA LARM
3
2
1
0
46
D- USING YOUR DEEP FREEZER
Control Panel
Green warning light will be on as long as your product runs.
Yellow light will be on when you press fast freezing button.
Red warning light will be on when the door of the freezer remains open for a long time or when you load fresh
food. The light will go off after closing the door or food starts freezing.
NOTE
Control panel on your product is not available for every model and it may vary in some models.
Place of the indicator lights and buttons on your product may be different than the ones shown herein. Thus
be careful to the colours stated in the control panel section.
Setting the Internal Temperature of your Product
Internal temperature of your device has been factory set in a manner that it will protect your food without causing them
spoiled.
In some models, the thermostat of your product is at compressor section. The temperature you desire can be set by
Authorized Uğur Service if requested.
When you run your product at factory set value, you get the best result in terms of both the performance and energy
consumption.
Run your device empty for at least three (3) hours. Therefore inside of your product will be cooled down in the best way.
You can set internal temperature of your product through the thermostat on the control panel:
You can set the thermostat by using a coin etc. that can enter the opening on the button. (Picture 24)
There are min-max and numbers between them on the thermostat button.
Operating ratio of your product will increase as you shift the button toward the position "MAX" and thus you will gain
more cooling.
Operating ratio of your product will decrease as you shift the button toward the position "MIN" and thus you will gain less
cooling.
Factory set thermostat value of your product is position (four) 4. This position is the most efficient position of the freezer in
terms of cooling and energy consumption.
3
2
1
5
6
7
S
Ürününüzün iç sıcaklığı -18°C ile -25°C olarak ayarlanabilmektedir.
The temperature can be set be set between -40°C and -45°C for UCF- SLF series freezers
The temperature can be set be set between -60°C and -65°C for UCF-LF series freezers
Internal temperature of your product can be set be set between -18°C and -25°C for freezers of other type.
3
2
4
4
1
S
5
PICTURE 24
47
EN