Renfert SILENT powerCAM EC Guia De Inicio Rapido página 21

In order to set the various different parameters, the programming mode must be started and the parame-
ter must be selected.
Start programming mode: Press operating mode key (21) for 3 seconds.
Select the parameter:
Change values:
Save settings:
Exit programming (no
changes):
Self-diagnosis (see Fig. D at the start of this manual)
Start the self-diagnosis manually. This is performed once.
Acoustic signal (see Fig. D at the start of this manual)
When switched on, various settings will be confirmed with an acoustic signal.
The audible signal can be switched on and off.
Time Interval for "Full" Display Dust Drawer (see Fig. E at the start of this manual)
After reaching a set time interval, a request appears to empty the dust drawer.
You can select between 5 times.
Time interval / hrs
2
5
10
50
100
With devices which generate large amounts of dust, (e.g. sandblasting units) the time interval
"empty dust drawer" should be set to 5 hours, if necessary, to 10 hours.
Suction turbine after-run time (see Fig. E at the start of this manual)
After-run time = The period of time between the OFF command in the CAM system and moment the suc-
tion turbine actually stops functioning.
It is possible to select between 6 different times.
After-run time / Secs.
0
3
5
10
20
30
In order to prevent the suction unit from switching on/off too frequently in the event of short inter-
ruptions, it is advisable to select a higher time.
Press the 0perating mode key (21), the corre-
sponding display blinks, the other displays are
on.
Press the extraction force keys (23).
Press the enter key (25). An audible signal
confirms successful saving.
Press operating mode key (21) again.
Blink signal in the display
1 x
2 x
3 x
4 x
5 x
Blink signal in the display
1 x
2 x
3 x
4 x
5 x
6 x
- 5 -
21
23
Factory setting
Factory setting
EN
25