Product Description - Renfert SILENT powerCAM EC Guia De Inicio Rapido

Product Description

Components Groups and Functional Elements
See Fig. 1 (on inside cover)
1 SILENT powerCAM EC
2 Key-pad
3
On / Off switch
4 Dust drawer
4A Clamp fastener
5 Fine filter
6 Suction port
7 Velcro® strip
See Fig. 2 (on inside cover)
3
On / Off switch
20 Display CAM-mode
21 Operating mode key, CAM-mode /
continuous operation
22 Display continuous operation
23 Extraction force -key
Setting Up
Setup
The extraction unit is a free standing appliance which must not be operated in a lying position.
If the extraction unit is kept in a closed cupboard, the warm exhaust air must be allowed to escape
using one of the methods, shown on the pictures A, B, C at the begining of this document.
A: External ventilation duct (see accessories at www.renfert.com).
B: Observe the opening in the cabinet, specified measurements, minimum and maximum distances.
C: Remove the back side of the cabinet, the distance from the back side of the cabinet to the wall
min. 50 mm.
Connect
Warning risk of injury!
When shortening the suction tube, please be sure to cut the integrated wire as straight as possible.
Long suction tubes, tight bends and kinks greatly reduce the suction power at the suction point.
⇒ If necessary, shorten the suction hose.
⇒ Open the Velcro® strip (7).
⇒ Place the suction hose with the end bushing (12) into the suction port (6).
⇒ Fasten the suction hose with the Velcro® strip.
⇒ Connect the suction hose to the suction port on the CAM device.
If the diameter size does not correspond, please use an adapter (see accessories) to prevent a
loss in suction performance.
⇒ Insert the interface cable to the CAM system in the CAM interface (8).
To connect the CAM device to the interface socket on the extraction unit (8), please see the inter-
face specifications in the complete instructions for use in the Internet and check the CAM device
instructions.
Only ever use the CAM interface which is provided for remote control of the extraction unit.
For CAM systems which only provide a switched mains voltage, it is essential to use "interface
cable type F". If the suction is frequently switched on or off via the CAM power supply, it may
cause electronic damage to the CAM system as well as to the SILENT compactCAM.
⇒ Switch the device off at the on / off switch (3).
⇒ Unroll the mains cable (9) and insert the plug into the building's electrical socket.
8 CAM interface
9 Mains cable
10 Device protection switch (2 x)
11 Exhaust air filter / exhaust air outlet
12 Suction hose with end bushings
13 Disposal bag
14 Holder
24 Display empty suction drawer
25 Enter key, save input
26 Display error message
27 Cover (do not remove, service interface)
- 3 -
EN