GYS PACK AUTO Manual De Instrucciones página 10

Translation of the original instructions
Do not place the device near a fire or subject it
to heat or to longterm temperatures exceeding
50°C.
Do not obstruct the cooling vents. Refer to the ins-
tallation section before operating the machine.
The automatic mode of operation and usage res-
trictions are explained below in these operating
instructions.
The booster must be stored in a vertical position. Any
other storage position should only be temporary.
Risk of explosion or acid projection in case of
short-circuit of the clamps or if the 12V booster is
connected to a 24V vehicle or vice versa.
Risk of explosion and fire!
A battery being charged can emit explosive gas.
• During the charge, the battery must be placed
• Avoid flames and sparks. Do not smoke.
• Protect the electrical contacts of the battery
Connection / disconnection:
• Disconnect the power supply before connec-
• The terminal of the battery that is not connec-
• After the charging process, disconnect the bat-
Acid projection hazard!
10
GYSPACK AUTO / 400 / 600
in a well ventilated area.
against short-circuiting.
ting/disconnecting the device to/from the bat-
tery.
ted to the car frame must be connected first.
The other connection must be made on the car
frame, far from the battery and the fuel line. The
battery charger must be connected to the power
supply network.
tery charger from the power supply network and
remove the connector from the car frame and
then the connector from the battery, in this order.
EN