Set the switch of the brush speed to the
desired speed.
LO: 150 revolutions per minute
HI: 300 revolutions per minute
Turning on the Appliance
ATTENTION
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
Insert the mains plug into a socket.
Adjust the handle to the desired work-
ing position. See chapter "Adjusting the
working position of the handle".
Hold the handle with both hands.
Depress the unlocking button and keep
it depressed.
Use the ON/OFF switch.
To do this, swivel the handle down at
least 3 steps from the vertical position.
Figure: Unlock the ON/OFF switch
Release the unlocking button.
Release the ON/OFF switch to interrupt
operation.
Control the direction
– Left: Press the handle downward.
– Right: Raise the handle.
Apply the detergent solution to the floor
or use the dosing lever of the detergent
tank (option).
Move the appliance over the surface to
be cleaned.
Repeat process for severe contamina-
tion.
Afterwards, pick up the wastewater with
a wet vacuum or a cloth.
12
Cleaning
Shutting down
Disconnect the mains plug from the
socket.
Pull the lever for level adjustment.
Move the handle into a vertical position.
Release the lever for level adjustment.
Remove the detergent tank (option) and
dispose of unused detergent solution.
Wind the mains cable around the cable
hooks.
Rinse the detergent tank (option) with
clear water.
Place the appliance into the parking po-
sition.
Remove the driver plate / disc brush.
Clean the casing with a damp cloth.
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
Pull the lever for level adjustment.
Move the handle into a vertical position.
Release the lever for level adjustment.
Tilt the appliance backwards into the
transport position and drive it to its des-
tination location.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.
Place the appliance into the parking po-
sition.
Store the appliance in a dry room, frost-
protected room.
Care and maintenance
DANGER
Risk of injury. Pull the plug from the mains
before carrying out any tasks on the appli-
ance.
Rinse contaminated disc brushes with
water.
EN
– 4
Transport
Storage