AL-KO 144F Manual Del Usuario página 12

Tanks
Always observe the operating
instructions Safety
Warning!
Gasoline is intensely fl ammable - burn danger!
Only store gasoline in the containers provided
for it
Only tank up outdoors
Do not smoke near the tanks
Do not open the tank closure near running or hot
motors
Replace damaged tank or tank closure
Always close the fi ller cap securely
When gasoline has emptied:
Do not start motor
Avoid starting attempts
Clean equipment
Caution!
Before putting into operation, fi ll with oil!
Fill with oil
(Illustration E)
1. Screw out the dipstick and press in fi ller pipe.
2. Screw out dipstick again.
Fill up with gasoline
The fuel tank cap is found on the gasoline tank
and is identifi ed with the symbol "Zapfsäule"
(gas pump).
1. Take off fuel tank cap.
2. Fill tank up to the lower brink of the fi ller pipe. Do not
overfi ll!
12
Oil recommendations
Motor oil is a critical factor for the motor's
performance and life expectancy. Use a motor oil
that satisfi es the requirements API service class SJ
(equals or exceeds).
Examine the API service label on the oil container so
that you are assured that it contains the letters SJ,
their equivalent or higher.
SAE 10W-30 is recommended for general use. The
recommended operating temperature range for this
motor is from -15°C to 40°C.
Oil level check (Illustration B)
Check motor oil status while motor is stopped and
standing horizontally.
1. Remove the oil-fi lling pipe/dipstick and wipe clean.
2. Insert the dipstick into the oil-fi lling pipe, without turning
it, and take out again.
3. If the oil level lies near to or underneath the lower
fi ll-mark on the dipstick, fi ll the recommended oil to the
upper limit mark.
4. Fit in the oil-fi lling pipe/dipstick again.
Lower oil levels can result in motor damage.
Fuel recommendations
Use clean, fresh, lead-free normal gasoline with
a minimum octane rating of 87.
Buy fuel in amounts that can be used within 30
days (see storage).
Do not use gasoline containing methanol.
Do not mix gasolline with oil.
Translation of original user instructions