Optional Accessory - DeWalt D25832 Manual De Instrucciones

English
SHOCKS® Active Vibration Control
System
For best vibration control, hold the tool as described in
Proper Hand Position and apply just enough pressure so
the damping device on the main handle is approximately
mid stroke. The hammer only needs enough pressure to
engage the active vibration control. Applying too much
pressure will not make the tool chip faster and active
vibration control will not engage.
D WALT Tool Tag Ready (Fig. A)
e

Optional Accessory

Your hammer comes with mounting holes
fasteners for installing a D WALT Tool Tag. You will need a
e
T15 bit tip to install the tag. Only use the screws provided.
The D WALT Tool Tag is designed for tracking and locating
e
professional power tools, equipment, and machines using
the D WALT Tool Connect™ app. For proper installation
e
and use of the D WALT Tool Tag refer to the D
e
Tag manual.
Electronic Speed and Impact Control
(Fig. A)
The electronic speed and impact control allows the use of
smaller chisels without the risk of chisel breakage, chipping
into light and brittle materials without shattering and
optimal tool control for precise chiseling.
To set the speed dial , turn the dial to the desired level.
8
The higher the number, the greater the speed and impact
energy. Dial settings make the tool extremely flexible and
adaptable for many different appli cations. The required
setting depends on the chisel size and hardness of material
being chipped.
Service Indicator LEDs (Fig. A)
Your chipping hammer has two service indicator LEDs
Refer to the table for more information on LED functionality.
lED Function Description
Red service
(flashing)
The red indicator LED
up if there is a fault with the tool
or the brushes have completely
worn out.
Yellow Brush service
(permanently on)
The yellow brushwear indicator
LED
brushes are nearly worn out,
indicating that the tool needs
servicing within the next 8 hours
of use.
Mode Selection (Fig. E)

WARNING: Do not select the operating mode when
the tool is running. Tool must come to a complete stop
6
10 and
WALT Tool
e
9 .
9 lights
lights up when the carbon
9
before activating the mode selector button or damage
to the tool may result.
Your tool is equipped with a mode selector dial
select the mode appropriate to desired operation.
symbol Mode
Chisel
Adjustment
Chipping
To Select a Mode
• Rotate the mode selector dial
arrow points to the symbol corresponding for the
desired mode.
Fig. E
nOTE: The arrow on the mode selector dial
pointing at a mode symbol at all times. There are no
operable positions in between.
Performing an Application (Fig. F)

WARNING: TO REDUCE THE RISK OF PERSONAL
INJURY, ALWAYS ensure workpiece is anchored or
clamped firmly.
nOTE: Operating temperature of this tool is 19 ˚F to 104 ˚F
(-7 ˚C to +40 ˚C). Using the tool outside of this temperature
range will decrease the life of the tool.
1. Insert the appropriate chisel and rotate it by hand to
lock it into the desired position. Refer to Chisel and
Chisel Holder.
2. Using the mode selector dial
Refer to Mode Selection.
3. Adjust the side handle
2
Fig. F
4
2
4. Place the chisel on the desired location.
5. Depress the rocker switch
6. To stop the hammer, release the switch.
4 to
Application
Chisel position
adjustment
Light chipping, chiseling
and demolition
so that the
4
4
4 must be
4 , select chipping mode .
as necessary.
1
.
1