Set The Timeout Lock In Admin Mode - Kingston DataTraveler 2000 Manual De Instrucciones

Set the Timeout Lock in Admin Mode

To protect against unauthorized access when the DT2000 is connected to a host and unattended, the DT2000
can be set to automatically lock after a pre-set amount of time.
In its default state, the DT2000 Timeout Lock feature is turned off. The Timeout Lock feature can be set to
activate (lock) anywhere between 1 and 99 minutes. Admin Timeout Lock settings will override User settings.
To set the Timeout Lock please follow steps in the table below.
Only do these steps when DT2000 is disconnected from a Host system.
Note:
Entering the Admin PIN to access a locked drive will clear the User PIN. For security
Caution:
reasons, we highly recommend that a new User PIN be created immediately once the drive
has been unlocked using the Admin PIN. Refer to
Instructions
1. Unlock the DT2000 with Admin PIN
2. Press the KEY button 3 times (triple-
click)
3. Within 10 seconds begin to press
button number 8 (Tuv) followed by
the number 5 (jkL) button - (85)
4. Press KEY button once
5. Within 10 seconds begin to enter the
length of User Timeout in 2 digits:
00 = 0 minutes (default)
01 = 1 minute
99 = 99 minutes, etc.
6. Press the Key button once
Document No. 480ADT2000.B00
LED
Creating a New User PIN in Admin
LED State
solid LED followed by a flickering
Red
LED indicating successful Admin PIN entry
and LEDs flicker together awaiting
Green Blue
new instructions in OPTIONS mode.
and LEDs continue to flicker together
Green Blue
Blinking LED
Green
LED continues to blink
Green
solid LED changing to flickering
Red
Admin can override USER Lock Timeout
DT2000
Mode.
Green
LED.
Green
Page 21 of 30