Set The Timeout Lock Mode In User Mode - Kingston DataTraveler 2000 Manual De Instrucciones

Set the Timeout Lock Mode in User mode

To protect against unauthorized access when the DT2000 is connected to a host and unattended, the DT2000
can be set to lock automatically after a pre-set amount of time. In its default state, the DT2000 Timeout Lock
feature is turned off. The Timeout Lock feature can be set to activate (lock) anywhere between 1 and 99
minutes.
To set the Timeout Lock, follow steps in the table below.
Note: Only do these steps when DT2000 is disconnected from a Host device.
Instructions
1. Unlock the DT2000 with the User
PIN
2. Enable Options by pressing the
KEY 3 button times (triple-click)
3. Within 10 seconds, enter the
number 8 (tuv) followed by the
number 5 (jkl) button - (85)
4. Press KEY button once
5. Within 10 seconds, enter the length
of User Timeout in 2 digits:
00 = 0 minutes (default)
01 = 1 minute
99 = 99 minutes, etc
6. Press the KEY button once
Document No. 480ADT2000.B00
LED LED Status
solid LED changes to
Red
indicating successful User PIN entry
and
Green Blue
awaiting new instructions in OPTIONS Mode
and
Green Blue
together
Blinking LED
Green
LED continues to blink
Green
solid LED - Timeout Lock has been
Green
enabled
DT2000
solid LED
Green
LEDs blink together –
LEDs continue to blink
Page 12 of 30