GYS NOMAD POWER 300 Manual De Instrucciones página 9

Translation of the original instructions
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
the device to/from the battery.
• The terminal of the battery that is not connected to the car
frame must be connected first. The other connection must be
made on the car frame, far from the battery and the fuel line.
• After the start-up operation, disconnect the booster. First remove
the chassis connection and then the battery connection, in the
order shown.
Class III device (NOMAD POWER).
Entretien :
• The power supply cable cannot be replaced. If the cable is
damaged,the device should not be used (NOMAD POWER
charger).
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• Under no circumstances should solvents or other aggressive
cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
• Equipment in compliance with British requirements. The
British Declaration of Conformity is available on our website
(see home page).
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our
website (see cover page).
Disposal:
• This product should be disposed of at an appropriate
recycling facility. Do not dispose of in domestic waste.
• The battery must be removed from the device before the
latter is discarded.
• The battery must be dropped off at a suitable recycling facility.
• The device must absolutely be disconnected from the power
supply network before removing the battery.
NOMAD POWER 300 / 400
EN
9