GYS NOMAD POWER 300 Manual De Instrucciones página 11

Translation of the original instructions
3
4
30"
5
6
7
CHARGING MOBILE PHONES
POWER SUPPLY (NOMAD POWER 400)
For electronic products 12 V
FLASHLIGHT FUNCTION
NOMAD POWER 300 / 400
If the lights «Start» and «Error» flash alternately in green and red, the
product is ready.
If only the «Error» light is on, the internal battery of the NOMAD POWER is
too low. Charge the product.
If the «Start» light becomes green and the «Error» light turns off, everything is ok.
Make a start within 30 seconds.
Do not exceed 3 starts with a time interval of 30s between each.
!
After starting, disconnect the smart start cable from its connector and remove the 2 clamps
from the vehicle's battery terminals within 30 seconds.
Leave the vehicle running.
!
If all 3 starts fail, check the «Error» light.
A red «Error» light on is synonymous with an engine or connection problem.
After the start-up, if the internal battery is less than 80%, recharge the NOMAD POWER.
Wait at least 30 minutes after starting the vehicle to charge the NOMAD
!
POWER.
1 - Plug your cable to the NOMAD POWER USB port 1 (2) or USB port 2 (3).
2 - Select the appropriate adaptor for your mobile phone or table and plug it in.
The NOMAD POWER launches the charge automatically.
Press the ON/OFF button (6) for 3 seconds to turn on the LEDs.
Briefly press the button (6) to switch lighting modes (3 available modes:
normal, stroboscope and SOS).
1 - Connect a 12 V power supply cable (not supplied) to the 12V
5 A output port (5).
2 - Link the power supply cable to the power socket of your 12
V electrical device.
EN
11