Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Customer Assistance - Bosch PST 18 LI Manual Original

OBJ_BUCH-1204-001.book Page 27 Wednesday, May 5, 2010 8:13 AM
Parallel Cuts (see figure L): Loosen the locking
screw 26 and slide the scale of the parallel guide
through the lead 21 in the base plate. Set the
desired cutting width as the scale value on the
inside edge of the base plate. Tighten the lock-
ing screw 26.
Circular Cuts (see figure M): Drill a hole (large
enough to accomodate the saw blade) close to
the cutting line within the circle to be sawn.
Work the drill hole with a router or file to ensure
that the saw blade faces flush against the cut-
ting line. Reposition the locking screw 26 on the
other side of the parallel guide. Slide the scale
of the parallel guide throught the lead 21 in the
base plate. Drill a hole in the centre of the cut-
out to be sawn. Insert the centring tip 28
through the inside opening of the parallel guide
and into the drilled hole. Adjust the radius as
scale value at the inside edge of the base plate.
Tighten the locking screw 26.
Coolant/Lubricant
When sawing metal, coolant/lubricant should be
applied alongside cutting line because of the
material heating up.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. There is danger
of injury when unintentionally actuating the
On/Off switch.
For safe and proper working, always keep
the machine and ventilation slots clean.
When the battery is no longer operative, please
refer to an authorised after-sales service agent
for Bosch power tools.
Clean the saw blade holder regularly. For this,
remove the saw blade from the machine and
lightly tap out the machine on a level surface.
Bosch Power Tools
Heavy contamination of the machine can lead to
malfunctions. Therefore, do not saw materials
that produce a lot of dust from below or over-
head.
Lubricate the guide roller 12 occasionally with a
drop of oil.
Check the guide roller 12 regularly. If worn, it
must be replaced through an authorised Bosch
after-sales service agent.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
After-sales Service and Customer As-
sistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer service representatives can an-
swer your questions concerning possible appli-
cations and adjustment of products and acces-
sories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: [email protected]
English | 27
2 609 004 236 | (5.5.10)