Cuisinart Elite 2.0 FP-14N Serie Instrucciones Y Libro De Recetas página 18

Solution:
• Divide dough into 2 or 3 pieces and
redistribute evenly in bowl. Process 10
seconds or until uniformly soft and
pliable.
8. Problem: Dough is too dry.
Solution:
• While machine is running, add water, 1
tablespoon at a time, until dough cleans
the inside of the bowl.
9. Problem: Dough is too wet.
Solution:
• While machine is running, add flour, 1
tablespoon at a time, until dough cleans
the inside of the bowl.
Technical
1. Problem: The motor does not start.
Solution:
• There is a safety interlock to prevent the
motor from starting if it is not properly
assembled. Make sure the work bowl
and work bowl cover are securely locked
into position.
• If you are slicing or shredding and the
above solution does not work, make sure
that the food contents in the feed tube are
cut below the maximum fill line so that
activation rod can engage the motor.
• If the motor still will not start, check the
power cord and outlet.
2. Problem: The food processor shuts off
during operation.
Solution:
• The cover may have become unlocked;
check to make sure it is securely in
position.
• A safety protector in the motor prevents the
motor from overheating, which is caused by
excessive strain. Press the Off control
button and wait 10 to 15 minutes to allow
the food processor to cool off before
resuming.
3. Problem: The food processor cover
becomes unlatched in the back and/or
makes a loud noise.
Solution:
• The back of the cover becoming unlatched,
and any related noise, will not prevent the
unit from working. Simply push down to
lock the back into position.
4. Problem: The motor slows down during
operation.
Solution:
• This is normal as some heavier loads (e.g.,
slicing/shredding cheese) may require the
motor to work harder. Simply reposition the
food in the feed tube and try again.
• The maximum load capacity may have
been exceeded. Remove some of the
ingredients and continue processing.
5. Problem: It is difficult to remove the
chopping/mixing blade from the work bowl.
Solution:
• These innovative blades have been
designed to lock in the work bowl to
prevent them from falling out when
emptying the contents of the bowl. Using
extreme care, use a little extra force to
remove the blade.
6. Problem: The food processor vibrated/
moved around the countertop during
processing.
Solution:
• Make sure the rubber feet at the bottom of
the unit are clean and dry. Also make sure
that the maximum load capacity is not
being exceeded.
• This is normal as some heavier loads (e.g.,
slicing/shredding cheese) may require the
motor to work harder.
7. Problem: The large pusher falls out when the
cover is turned upside down.
Solution:
• The pusher lock feature, located above the
handle, should be pulled out.
18