Serial Interface Connections - Adam Equipment EQUINOX EAB Manual De Usuario

N.B. Check that the power shown on the balance plate label corresponds to the one in
use in the country of use.
All models:
Wait 30 minutes after switching on and calibrate the balance after leveling it. For calibration
procedures, please refer to the "calibration chapter". Perform the balance calibration
whenever it is moved to another place.
Do not drop excess weight objects on the balance weighing plate to prevent damaging it.
Service must be performed by specialized personnel and the spare parts used must be
genuine. To do so, contact the dealer or Adam Equipment at www.adamequipment.com.

3.0 SERIAL INTERFACE CONNECTIONS

The balance is equipped with an RS 232C interface for connection to a serial printer.
To ensure communication between the balance and a printer, the following conditions must
be met:
Connect the printer using a suitable cable matching the position of the pin outputs with the
balance pin outputs shown below.
Set the transmission speed and type of printer correctly according to the parameters of the
printer. See Chapter 6.9.
N.B. It is recommended that you use the Adam ATP printer to ensure proper print operation.
(If you are using different printers, you may not be able to print the chart).
© Adam Equipment 2018 8