Initial Cleaning; Preparation Of Coffee; Measuring The Coffee Powder; Preparing The Coffee - Hogastra Eco-Line CNS 35 Descripción Del Funcionamiento

GB

4.3 Initial Cleaning

Debris in the coffee machine can distort the taste of the coffee that
is prepared first. Therefore, it is important to clean the appliance
thoroughly before its first use.
NB.
The coffee prepared during the first use of the appliance
cannot be used and must be disposed of.
1. Fill the coffee machine up to the highest mark with cold water.
2. Attach the filter disk and the riser tube onto the filter attach-
ment (see chapter 5.2 "Preparing the coffee").
3. Put 2-3 cups of coffee powder into the filter
4. Close the lid.
5. Press the on/off switch.
The coffee machine will begin to brew the coffee automatically.
6. After the coffee has finished brewing, press the on/off switch.
The coffee machine will turn itself off.
7. Dispose of the prepared coffee.
Preparation of the Coffee

5.1 Measuring the coffee powder

ATTENTION
Pay attention to the fact that the lowest possible amount
that the coffee machine can be filled is about 15 cups (2
litres) The markings inside the machine, show the level to
which it has been filled.
If the machine is not filled to this level, the brewing pro-
cess does not begin.
NB
You can add different amounts of coffee powder to match
your own personal taste.
If you use more coffee powder, the coffee will be stronger,
if you use less coffee powder, the coffee will be weaker.
Mark the table of your model with a cross
again quickly.
Model CNS 35/CNS 35 CL (2,0l – 4,5l)
15
20
25
30
35
Model CNS 50/CNS 50 CL (2,0l – 6,5l)
15
20
25
30
35
40
45
50
Model CNS 75/CNS 75 CL (2,0l – 9,5l)
15
30
40
50
60
75
38
5
so that you can recognise it
c. 150 g 2.5 x
c. 180 g 3.0 x
c. 210 g 3.5 x
c. 240 g 4.0 x
c. 270 g 4.5 x
c. 150 g 2.5 x
c. 180 g 3.0 x
c. 210 g 3.5 x
c. 240 g 4.0 x
c. 270 g 4.5 x
c. 300 g 5.0 x
c. 330 g 5.5 x
c. 360 g 6.0 x
c. 180 g 3.0 x
c. 240 g 4.0 x
c. 300 g 5.0 x
c. 345 g 6.0 x
c. 390 g 7.0 x
c. 450 g 8.0 x
Model CNS 100/CNS 100 CL (2,0l – 12,5l)
15
25
35
45
55
65
75
85
100
Modell CNS 130/CNS 130 CL (2,0 l – 16,5 l)
15
30
45
60
75
90
105
120
130
Model CNS 160/CNS 160 CL (2,0l – 20,0l)
15
30
45
60
75
90
105
120
130
150
160

5.2 Preparing the coffee

WARNING
During the brewing process, the parts of the machine heat
up to a temperature of up to 90°C and can lead to severe
burns if used inappropriately.
• Touch only the handles of the coffee machine when it is
hot.
Fill the appliance with water as follows:
Fill the coffee container at least to the lower and at most to the hig-
her mark (see Chapter 5.1 „ Measuring the coffee powder ").
1. Open the lid
2. Remove the filter attachment and the standpipe.
3. Fill the coffee container with cold water up to the higher mark.
Attach the CNS-Sheet filter as follows:
1. Wet the CNS-sheet filter under running water.
This causes a strong adhesion of the coffee powder to the sheet
filter.
2. Lead the hole in the middle of the CNS sheet filter over the point
of the guide jacket.
3. Press your thumb and index finger at
4. Lead the ring of the stainless steel clip
c. 180 g 3.0 x
c. 225 g 3.5 x
c. 270 g 4.5 x
c. 315 g 5.0 x
c. 360 g 6.0 x
c. 405 g 7.0 x
c. 450 g 7.5 x
c. 480 g 8.0 x
c. 540 g 9.0 x
c. 180 g 3.0 x
c. 240 g 4.0 x
c. 300 g 5.0 x
c. 360 g 6.0 x
c. 420 g 7.0 x
c. 480 g 8.0 x
c. 540 g 9.0 x
c. 600 g 10.0 x
c. 660 g 11.0 x
c. 180 g 3.0 x
c. 240 g 4.0 x
c. 300 g 5.0 x
c. 360 g 6.0 x
c. 420 g 7.0 x
c. 480 g 8.0 x
c. 540 g 9.0 x
c. 600 g 10.0 x
c. 660 g 11.0 x
c. 720 g 12.0 x
c. 750 g 12.5 x
both ends of the stainless steel clip.
Through this, the ring of the stainless
steel clip becomes bigger.
over the guide jacket of the filter
attachment, until this lies directly on
the CNS filter disk.