Service And Repair - Leister TWINNY T Instrucciones De Funcionamiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
Training
• Leister Technologies AG and its authorised Service Centres offer free welding courses and training.
Informationen below www.leister.com.
Accessories
• Only Leister accessories should be used.
Maintenance
• The tool's air filter (26) should be cleaned with a fine brush when dirty.
• Clean combination wedge (18) with a wire brush.
• The drive and pressure roller (22/23) should be cleaned with a wire brush.
• Treat the chain (24) with a suitable spray as required.
• Check mains cable (1) and plug for electrical and mechanical damage.

Service and repair

• The tool should be checked after a maximum of approx. 1000 hours running time by an authorised Service
Centre.
• Repairs should only be carried out by authorised Leister Service Centres. They guarantee a correct and
reliable repair service within reasonable period, using original spare parts in accordance with the circuit
diagrams and spare parts lists.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of gu-
arantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery document.
Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
26
19
Tabla de contenido
loading

Este manual también es adecuado para:

118.609

Tabla de contenido