Maintenance - MyTek 3399 Manual

Maintenance

(1)The left, right and rear filters on air-inlet grills can be pulled up and out without removing any screws.
Please perform cleaning as needed.
(2) Routine water drainage maintenance: please remove the cap (N) located at the bottom of the
appliance. Allow the water tank to drain completely before replacing the cap (N). Refill the water tank
with fresh water, and the wipe dirt and dust from the surface of the unit with a damp cloth.
(1)
To obtain the best results, allow the Honeycomb Cooling Pads to dry after each use by turning off the
cooling pump and turning on the fan 15 minutes before turning off the unit.
* Please disassemble or clean the appliance only after water is drained and the power cord is unplugged.
* P lease drain all the water in the tank and dry the Honeycomb Cooling Pads, if the appliance will not be
used for an extended time.
* T he cleaning frequency for the Honeycomb Cooling Pads depends on local air and water conditions.
* I n areas where water mineral content is high, deposits may build up on the Honeycomb Cooling Pads and
restrict the air flow.
* I t is recommended that cleaning and draining the water tank, and then refilling it with clean fresh water
once a week may help reduce mineral deposits. If mineral deposits build up on the Honeycomb Cooling
Pads, please remove the pads and wash them gently under fresh water.
* N ever use corrosive elements or chemicals to clean this product.
* W hen the unit is not in use, please store the Cooler in a dry place away
from direct sun.
* W hen it is necessary to store the Cooler due to seasonal changes, the
power cord can be stored on the cable storage hooks (M) on the rear side
of the appliance.
(2)
N
12
M