Maintenance Cleaning - MyTek 3400 Manual Del Usuario

Maintenance Cleaning

Note:
Depending on the environment, the Honeycomb pads should be cleaned at least every two months, or sooner.
Steps to remove/install the honeycomb filters:
(1) Remove each screw on the side air inlet hoods (F) or the rear air inlet hoods (J), and open them
outwards. There are four air inlet hoods.
(2) Remove the side air inlet hoods (F) and the rear air inlet hoods (J), and take out the four pieces of
honeycomb cooling filters (E).
(3) To assemble the honeycomb cooling filters (E) back to the water-cooling fan, take the reverse steps
from step 2 to step 1.
(1)
F
For regular maintenance, remove the drain plug cover (M) located at the bottom of the fan, wait till the
water in the water tank is drained, lock the drain plug cover (M) back and fill in new water. Wipe the
surface of the fan with a piece of wet cloth to clean the dirt and dust on it.
(2)
J
M
16
(3)
E