Operation Introduction - MyTek 3399 Manual

Operation Introduction

Continuous Water Supply Connection :
(1) For a continuous water supply, you will need a water hose
that is connected to a main water supply (please find a
suitable water hose, one that fits the connector, as a hose
is not included).
(2) Insert the connector into the water hose (included in the
parts bag), and Insert the hose along with the connector
into the water inlet valve of the cooler. Screw and tighten
the water hose connector onto the water inlet valve,
making sure that the hose connector is secure and that
there are no leaks.
* If there is leakage, the hose and the water inlet valve may not
be connected properly.
*P lease disconnect and reconnect and re-tighten the water inlet valve.
When the connection is secure, turn on the water supply system and
confirm that the water is properly flowing into the water tank.
*P lease place the Cooler on a level surface. A slanted floor may cause
sliding and danger, and/or cause water overflow when the water tank is full.
*W hen the water tank is full, the water inlet valve will automatically stop the water supply. Please adjust
the water valve to control the flow if there is any overflow, as excessive pressure may damage the inlet
pressure control system.
WARNING: Maximum allowable water inlet pressure is 50 psi (3.5
Manual Water Tank Refill :
You may pour in water directly from the ice-loading compartment on the left and right side of the Cooler,
or place frozen water bottles or ice cubes, to refill the water tank. To see if the water tank is full, check the
"water level indicator window" in front of the Cooler.
* Do not add water, water bottles or ice cubes, when
the water indicator is at the "Maximum" level to avoid
water overflow.
*P lease ensure that the level of the water in the tank
is always above the minimum water level mark for
Continuous & Manual Water Refill operation. Running
the Cooler in Cooling mode with inadequate water
may cause pump failure.
*D o not fill the water tank with dirty or salt water. Such
contamination can damage the water pump and
Honeycomb cooling pads. "Water capacity" refers to
the total volume of water that can be contained within
the Cooler's water tank and water distribution system.
11
kgs ).
2
cm