Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Control Panel Functions
Wind Speed Knob
[
]
Cooling Mode
To operate in the cooling mode, you must add water before operating the Cooler;
Note :
to enhance the cooling effect, add ice cubes after adding water to increase the effect.
Turn the Cooling Knob from 0 to 1 (0 is off, 1 is on) to activate the "evaporative cooling" function.
After the water pump starts running, the honeycomb cooling pad will be completely moist and you
will feel the cool air.
[
]
Wind Speed Knob
Connect the power and turn the middle wind speed knob to activate the Cooler; turn the wind speed in
the 0 to 1 direction to select fan speed. (1 for Low, 2 for Medium and 3 for High)
To shut off the Cooler, please turn the wind speed knob to the
0 position, and turn off the power switch.
[Swing Knob]
The louver blades are preset to automatically move in the
left-and-right direction. To change the up-or-down wind
direction, manually adjust the blades in front of the cooling
fan to the desired direction.
[Caution]
Please ensure that the water cooling fan is properly positioned
prior to installing and starting the product. Connect the hose to a "Continuous
Water Supply" to allow uninterrupted operation and to avoid having to manually
add water. If the Cooler is operating with an inadequate supply of water, this
may cause water pump failure.
Please be sure to unplug the power before refilling
Note :
or emptying the water tank.
[Secure the Brake]
To secure the Cooler, please push down the safety lever of the Rear Brake
Caster (I); to move the Cooler, please pull up the safety lever.
Cooling Mode
Wind Speed Knob
10
Swing Knob
I
Capítulos
Tabla de contenido
