Establishing A Water Supply; Selecting An Attachment; Fitting And Removing Attachments - Parkside PHD 135 D3 Traducción Del Manual De Instrucciones Origina

age or wear and tear. If the cable gets dam-
aged during use, it must be disconnected
from the supply network immediately. DO
NOT TOUCH THE CABLE BEFORE IT HAS
BEEN DISCONNECTED FROM THE POWER
SUPPLY. Do not use the device if the cable is
damaged or worn.
• Only connect the device to a power socket
with a residual current device (RCD) with a
rated residual current no more than 30 mA.
• Unsuitable extension cables can be danger-
ous. Use only extension cables that are de-
signed for outdoor use. The connection must
be dry and routed above the ground. We
recommend using a cable drum that holds
the socket at least 60 mm above the ground.

Establishing a water supply

Requirements
• Supply hose: Garden hose with fitted
quick connector (not included in delivery);
⌀ 13 mm (½"); length between 5 m and
30 m
• Domestic water connection with a system
separator; pump capacity of at least 450 l/h
System separator
A system separator (check valve) prevents the
backflow of water and cleaning agent into the
drinking water pipeline.
• According to current regulations, a pressure
washer must never be connected to the drink-
ing water network without a system separa-
tor. A suitable system separator must be used
in accordance with EN 12729 Type BA.
• Water that has flowed through a system sep-
arator is classified as non-potable.
• System separators are available from spe-
cialist dealers.
Connecting the water supply
1. Remove the quick connector with filter insert
(20) from the device water connection (21).
2. Connect the supply hose to the water supply.
3. Bleed the supply hose: Open the water sup-
ply until the water flows bubble-free out of the
other end of the supply hose. Close the wa-
ter supply.
4. Connect the quick adapter on the supply hose
to the quick connector with filter insert.

Selecting an attachment

Standard Vario nozzle (17)
The tip can be rotated and moved
Control elements
• Vario fan jet (direction of rotation as seen
from behind)
⭮ Wide jet
⭯ Narrow jet; spot jet
• Moveable tip
Low pressure for cleaning agent: Tip up
front
High-pressure operation: Tip at rear
Turbo dirt miller (19)
The rotating water jet is suitable for work-
ing with low water consumption.
Fitting and removing attach-
ments
Fitting the nozzle
1. Fit the lance (24) on the pistol grip (1) by in-
serting and turning it (Bayonet locking de-
vice).
2. Fit the attachment on the lance (24).
✔ The attachment clicks into place.
Removing the nozzle
1. Press the release button (18) on the front end
of the lance (24) and remove the attachment.
2. Remove the lance (24) from the pistol grip (1)
by turning and pulling it (Bayonet locking de-
vice). (Bayonet locking device) from the pistol
grip (1).
GB
IE
25