Repairs; Environmental Protection; Technical Specifications - Metabo W 14-125 Ergo Manual Original

R Steel wire brushes (always use with the hand
guard attached.)
S Adjusting nut (10)
T "Quick" clamping nut
For complete range of accessories, see
www.metabo.com or refer to the main catalogue.

12 Repairs

Repairs to electrical tools must be carried out
by qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault to the
power tool.

13 Environmental Protection

The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Metabo packaging is 100% recycled. Scrap power
tools and accessories contain large amounts of
valuable resources and plastics that can be recy-
cled.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately
and handed in for environmentally compatible
recycling.
These instructions are printed on chlorine-free
bleached paper.

14 Technical Specifications

Explanation of details on page 2 . Subject to
changes serving technical progress.
D = Maximum sanding disc diameter
max
t = max. permitted thickness of clamping
max,1
shank on accessory when using
clamping nut (10)
t = max. permitted thickness of clamping
max,2
shank on accessory when using
"Quick"clamping nut
t = Roughing disc/Parting disc:
max,3
max. permitted thickness of
accessory
M = Spindle thread
l = Length of the grinding spindle
n = No-load speed (maximum speed)
P = Nominal power input
1
P = Power output
2
m = Weight without mains cable
Vibration total value (vector sum of three
directions) determined in accordance with
EN 60745:
a = Vibration emission value (sanding
h, SG
surfaces)
a = Vibration emission value (sanding
h, DS
with sanding pad)
K = Uncertainty (vibration)
h,SG/DS
The vibration emission level given in this informa-
tion sheet has been measured in accordance with
a standardised test given in EN 60745 and may be
used to compare one tool with another. It is also
suitable for a provisional estimate of the vibratory
load.
The specified vibration level applies to the main
applications of the power tool. If the power tool is
used for other applications, however, and with
different tools, or maintenance is insufficient, the
vibration level can deviate. This can considerably
increase the vibratory load over the entire working
period.
For an accurate estimate of the vibratory load,
times in which the machine is switched off, or
when it is running but not actually in use, should
also be taken into consideration. This may signifi-
cantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
service the tool and the accessories, keep hands
warm, organise work patterns.
Typical A-effective perceived sound levels:
L = Sound pressure level
pA
L = Acoustic power level
WA
K = Uncertainty (noise level)
pA/WA
Wear ear protectors!
Measured values determined in conformity with
EN 60745.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH
ENG
19