Configuring Volume Measurement; Characteristic Curves - WIKA DMSU21SA Manual De Instrucciones

Sistema de monitorización de membrana con protocolo hart
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

8. Configuration via display and operating unit

8.3 Configuring volume measurement

Requirement
EN
1. Open the operating menu with [↵].
Select "Basic setting" and confirm with [↵].
2. Select "Application" and confirm with [↵].
3. Select "Level" and confirm with [↵].
4. Select "Unit" and confirm with [↵].
5. Select length unit and confirm with [↵].
» Length unit is set.
6. Select "Density" and confirm with [↵].
7. Select "Density unit" and confirm with [↵].
8. Select density unit and confirm with [↵].
» Density unit is set.
9. Select "Density value" and confirm with [↵].
10. Set digit using [▲] [▼] and confirm with [↵].
» The cursor moves to the next digit.
» Repeat for each digit.
» Density value is set.
11. Go back two menu levels using [ESC].
Select "Mode" and confirm with [↵].
12. Select "Level" and confirm with [↵].
» Mode is set.
30
Length unit for the fill level is known
Medium density is known
Characteristic curve of the tank is known (→ See chapter

8.4 "Characteristic curves")

WIKA operating instructions, model DMSU21A
Tabla de contenido
loading

Tabla de contenido