26/30
Troubleshooting
12.2 Resetting user settings
The following settings are reset:
• Storage location 1 to 4
• Upper user height
• Lower user height
• Collision detection
• Unit of the display
Button / display
or
P12
Button [1]
P30
Button [1]
Button [2]
12.3 Resetting the number of connected lifting modules
The automatic detection of the lifting modules is activated by default.
A reduced number is detected as dangerous fault. A higher number
is accepted.
If one lifting module fails, the control is blocked. Error code "F16" is indicated
in the display (A).
Check the connections of all lifting modules.
Replace the defective lifting module.
If the control is to be operated in a new configuration, proceed as follows:
Button / display
or
P14
Button [1]
Button [1]
or
Button [1]
Bosch Rexroth AG, MPS: Control unit, 3 842 559 935/2019-08
Instructions
Push shortly four times in a row
A tone sequence resounds and "PXX" is shown in the display (A)
Push to select a menu item
Service menu
Push to select menu item
Resetting user settings
Push to reset the values
Push to exit the menu
Instructions
Push shortly four times in a row
A tone sequence resounds and "PXX" is shown in the display
(A)
Push to select a menu item
Select menu item
Push to select menu item
The display shows "P60"
Push to select menu item
The display indicates the number of lifting modules stored
by the control unit.
Push to change the number of lifting modules.
Push to save the entry