Power Connection; Getting Started - König Electronic HAV-CR74 Manual Del Usuario

POWER CONNECTION

Plug the AC power cord to a household outlet AC source. This unit is equipped with a battery
back up system, it requires a 9 Volt battery (Not included). Insert the battery in the battery
compartment, making certain that the positive and negative (+ and -) battery terminals are
attached to the corresponding terminals on the plate in the battery compartment. If an AC
power failure occurs, the clock automatically switches to the battery power supply, the clock
and timer memory still continue to run. When the AC power resumes, the clock switches back
to AC again.

GETTING STARTED

Press the reset button (17) located on the back of unit after AC plug in.
- The unit will display full segment for 2 seconds, then it will enter normal mode.
- Display will lighten up.
1. TIME AND CALENDAR SETTING
A. Press Mode Set button (1) in normal mode and keep it pressed for longer than 2 seconds to
enter Time Set mode, after enter the setting mode, press Mode Set button (1) to change the
mode cycle as follows :
Normal → Year → Month → Day → 12/24H → RTC Hour → RTC Min → Normal
Action (during data adjustment) :
- Press button (7) to adjust data forward
- Press button (8) to adjust data backward
- Keep button 7 and 8 pushed in for 2 seconds to enable auto forward
a. Year Set Mode
Initial Value : 2006
Year Range : 2000 to 2099
Display Show Year Set Mode
b. Month Set Mode
Display Show Month Set Mode
3